Configuring a Legacy Router using MiniEdit from Mininet : networking

Hello all.

I have successfully created an SDN network and connected to ONOS controller. Everything runs perfectly. Now I want to add a legacy router (they are provided with MiniEdit) but I can’t seem to configure it correctly. The network is simple and can be found here it consists of two hosts and 3 SDN switches, a legacy router between two SDN switches and the controller.

I’d appreciate any help from any mininet/MiniEdit expert.


Host1 IP address is Host2 IP address is

I don’t usually assign IPs to the switches since ONOS takes care of identifying all openflow devices.

The terminal of the legacy router can load zebra, bgp and the configurations will be with the “configure terminal” command using >bgp >vtysh

Source link

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Back to top button

Adblock Detected

Please consider supporting us by disabling your ad blocker